Installing a VNXe3300 DPE in a Telco rack
EMC VNXe™3300 System Hardware Installation Guide for Telco Racks
7
Installing a VNXe3300 DPE in a Telco rack
This section describes the components of the VNXe3300 DPE mounting kit. It also
describes how to install the mounting kit in a Telco rack and how to install the DPE in the
mounting kit.
VNXe3300 DPE mounting kit (DPE-TELCO-3U/3US)
The following table lists and describes the components in the DPE mounting kit listed in
the table on
. Illustrations of the components of the kit can be found in
.
The quantity listed below is per enclosure.
Figure 3 3U DPE mounting kit components
Component
Quantity Use
Front support tray
1
Attaches to the front of the Telco rack
Rear support tray
1
Attaches to the rear of the Telco rack
Rear fastening bracket (left and
right)
2
Attaches to the rear corner of the
DPE and DPE rear tray
#10-32 x .5 in screw
20
6 to attach the front tray to the Telco rack
6 to attach the rear tray to the Telco rack
4 to attach the front tray to the DPE
4 to attach the rear brackets to the rear corners of the DPE
CL4827
