User manual Solar set XS
E18-XSSolarset-EN-00
www.emergoplus.com
Page 10 of 15
3.4
Mounting MPPT Solar charger
See manual of the Solar charger.
3.5
Gluing prescription
▪
Clean both adhesive surfaces with Activator.
▪
Allow the Activator to vaporise. This will take 10-15
minutes, depending on temperature and humidity.
▪
Roughen the surfaces to be glued with Scotchbrite Very
Fine.
▪
Clean both adhesive surfaces with activator.
▪
Allow the activator to vaporise. This will take 10-15
minutes, depending on temperature and humidity.
NOTE!
For a good and solid adhesive bond it is very
important that you act in accordance with
instructions below! Surfaces must be dry,
grease-free, oil-free and dust-free.
CAUTION!
As soon as the Solar panel is exposed to light,
it will start generating voltage! This voltage is
not touch-safe. Bear this in mind when
connecting the cabling! As an additional safety
you could cover the solar panel or protect it
against exposure to light, before you perform
any installation, maintenance or cleaning
activities.
