- 4 -
SJ-110659.1 EN
PARTS DESCRIPTION
1.
Pusher
2.
Hopper
3.
Strainer
4.
Jar
5.
Handle
6.
Juice spout with cap
7.
Pulp spout
8.
Motor base
9.
Rotary switch
10.
Power cord
11.
Pulp cup
12.
Juice cup
13.
Cleaning brush
BEFORE FIRST USE
Carefully wipe the exterior of the appliance to remove any dust that may have accumulated. Dry with a dry
towel. Do not use harsh abrasive cleaners.
Wash the parts in warm soapy water, dry with a dry towel. Do not immerse the power cord or motor part of
this appliance in water or any other liquids.
Wash the jar, strainer, hopper, pusher, juice cup and pulp cup in warm soapy water with a soft cloth or nylon
brush. Rinse and dry thoroughly.
ASSEMBLY
Before you assemble the juicer, ensure that the power cord is unplugged.
1.
Place the motor base on a flat dry surface.
2.
Underneath the jar is the pulp extraction silicon, which is used to remove the pulp from the spout of the jar.
Ensure that the silicon is firmly inserted into the hole. (Fig.1)
Fig. 1
3.
Place the jar on top of the motor base ensuring the 3 recess parts of the jar align with the 3 protuberant
parts on the motor base. Make sure the jar is all the way placed onto the shaft of the motor base stably.
(Fig.2)
4.
Put the strainer into the center of the jar. Push the strainer down and make sure the shaft go through the
strainer. (Fig.3)
Caution! The hopper cannot be closed up if the strainer is not placed properly.
a.
Silicon pulled out
b.
Silicon inserted in
c.
Juice spout
Summary of Contents for SJ-110659.1
Page 1: ......
