16
E.T.L. Model No.: CF985
8. Installation of Downlight Assembly
(Continued)
8.7
Place the light fitter glass bowl into the light fitter, aligning
the three flat areas on the top flange of the glass bowl with
the three raised studs in the light fitter.
Then turn the glass bowl clockwise until it stops and is
secure (Figure 29).
NOTE: Periodically check that the glass bowl is seated
fully clockwise in the light fitter.
Installation of your ceiling fan is now complete. Proceed
with installation of the wall control.
Proceed to Section 10 to install the wall control.
50-WATT (max.)
MINI-CANDELABRA BASE
HALOGEN BULBS (2)
LIGHT FITTER
SOCKETS (2)
LIGHT
FITTER
Figure 28
If using the No-light Cover Plate, skip this section and
go to Section 9.
8.6
Light Fitter Light Bulb Installation:
If light fitter is to be used as a down light,
screw in two
50-watt (maximum) mini-candelabra base halogen bulbs
(supplied) into the light fitter sockets (Figure 28).
CAUTION: To avoid risk of burns or other injury,
assure power is off before attempting to install or
replace the 50-watt (max.) mini-candelabra base
halogen bulbs. Halogen bulbs are very hot and can
cause burns. Allow the bulbs to cool sufficiently
before handling.
CAUTION: Do not touch 50-watt (max.) mini-
candelabra base halogen bulbs with bare hands.
Fingerprints may result in shorter bulb life. Remove
fingerprints with alcohol.
LIGHT FITTER
RAISED STUDS (3)
ROTATE GLASS BOWL CLOCKWISE TO
ENGAGE ON THE LIGHT FITTER RAISED STUDS
LIFT GLASS BOWL UP
INTO LIGHT FITTER
FLAT AREA
OF GLASS
BOWL (3)
GLASS
BOWL
Figure 29
