7
emersonfans.com
Please contact 1-800-654-3545 for further assistance
E.T.L. Model No.: CF985
CEILING
COVER
6" DOWNROD
Figure 6
3. Ceiling Fan Assembly
(Continued)
3.7
Route the 80” black and white motor leads through the
ceiling cover (Figure 6).
Place the ceiling cover over the downrod. Be sure both the
ceiling cover and the coupling cover are oriented correctly
(Figure 6).
HANGER
BALL
SETSCREW
PIN
6" DOWNROD
Figure 7
3.8
NOTE: Only use the hanger ball supplied with this
ceiling fan.
Route the two 80” motor leads through the hanger ball.
Reinstall the hanger ball (Figure 7) on the downrod as
follows:
Position the hanger ball pin through the two holes in the
downrod and align the ball so the pin is captured in the
groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin and securely
tighten the setscrew in the hanger ball.
NOTE: A loose setscrew could create fan wobble.
HANGER BALL/
DOWNROD
ASSEMBLY
6 to 9
INCHES
Figure 8
3.9
The fan comes with black and white leads that are
80-inches long.
Before installing the fan, measure up approximately
6 to 9-inches above top of hanger ball/downrod assembly
(Figure 8).
Cut off excess leads and strip back insulation 1/2-inch
from end of leads.
