Emerson AMHURST CF880BS00, Owner'S Manual

1.

Remove the hanger ball by loosening the setscrew in
the hanger ball until the ball falls freely down the
downrod (Figure 1). Remove the pin from the
downrod, then remove the hanger ball. Retain the pin
and hanger ball for reinstallation in Step 6.

2.

Loosen the two setscrews in the motor coupler to
prepare for the installation of the downrod (Figure 2).

3.

Separate, untwist and unkink the three 80” motor
leads. Route the motor lead wires through the
downrod. Align the clevis pin holes in the downrod
with the holes in the motor coupler. Install the clevis
pin and secure with the hairpin clip (Figure 2). The
clevis pin must go through the holes in the motor
coupler and the holes in the downrod. Be sure to
push the straight leg of the hairpin clip through the
hole near the end of the clevis pin until the curved
portion of the hairpin clip snaps around the clevis pin.
The hairpin clip must be properly installed to prevent
the clevis pin from working loose. Pull on the
downrod to make sure the clevis pin is properly
installed.

4.

While pulling up on the downrod, tighten the two
setscrews in the motor coupler (Figure 2).

Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 9). If you feel
you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.

WARNING

!

This Manual Is Designed to Make it as Easy as Possible for You to Assemble,

Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver
One stepladder
One wire stripper

Materials

Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would be
a 3-conductor (2-wire with ground) of following size:

Installed Wire Length

Wire Size A.W.G.

Up to 50 ft.

14

50-100 ft.

12

Ceiling Fan Assembly

4

ETL Model No.: CF880

HAIRPIN CLIP

MOTOR COUPLER

DOWNROD

CLEVIS 
PIN

HAIRPIN
CLIP

MOTOR
COUPLER

SETSCREWS (2)

CLEVIS PIN

REINSTALL 
SETSCREW (2)

Figure 2

DOWNROD

PIN

SETSCREW

HANGER BALL

Figure 1

It is critical that the clevis pin in the motor coupler is
properly installed and the setscrews securely
tightened. Failure to verify that the pin and setscrews
are properly installed (as shown in Figure 2) could
result in the fan falling.

WARNING

!