Appleton • 1.800.621.1506 • www.appletonelec.com
DOC000097A000 Rev. 01 01/11/21 MY7287 • Page 1 of 3
DOC000097A000 INSTRUCTION SHEET
Installation and Maintenance Instructions for Appleton™ Temporary
LED Worksite Lighting
IMPORTANT: RETAIN THIS INSTRUCTION SHEET FOR FUTURE REFERENCE. For safe installation and operation, please read
these instructions carefully and with full understanding.
Product Safety
Signal Words Defined
DANGER
indicates a hazardous situation which, if not avoided, will result in death or serious injury.
WARNING
indicates a hazardous
situation which, if not avoided, could result in death or serious injury.
CAUTION
indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
NOTICE
is used to address practices not related to physical injury.
Safety Instructions
WARNING
:
• DO NOT OPEN FIXTURE WHILE IT IS ENERGIZED.
• DO NOT USE FIXTURE ON UN-GROUNDED CIRCUITS. Failure to ground this luminaire can result in an electrical
shock which may be fatal.
CAUTION
:
• ELECTRIC SHOCK HAZARD: Disconnect from power (unplug) before servicing.
• ELECTRIC SHOCK HAZARD: DISCONNECT luminaire from power source before inspection or repair work
is attempted.
• Failure of the luminaire to operate could result from a break in the power circuit or failure of a component. In this
case, the luminaire is not operational, DO NOT operate.
• Take note of caution labels on product.
• Inspect cord regularly for damage.
• Do not submerge any part of product in liquids.
• Do not hang fixture by its electrical cord. Make sure to use the manufacturer’s handle or hanging hole located at
the top of the unit..
• Take care not to drop fixture, as damage to the product may result.
• Do not connect other loads such as appliances, space heaters or power tools to the light string.
NOTICE
:
• Please read this manual carefully before initial use to make sure the application is in accordance with all
instructions.
• To reduce the risk of electric shock and fire, do not exceed string maximum wattage including any additional
string loads. Maximum number of connected luminaires: 100W – 6 units.
• Luminaires are suitable for dry and damp locations, however, make sure to never submerge any part of the fixture
in liquids of any kind.
• Disconnect the power to avoid shock when the equipment is wet.
• This device is not intended for use with emergency exits.
• The product should not be installed in extreme heat, sealed environments, or areas with corrosive gases, so as
not to affect the service life.
• This luminaire must be installed, tested and maintained by professionals familiar with all national and local
electrical codes.
• Please inspect the product carefully after opening the package. If damaged, please keep the packaging and
immediately contact your local supplier.
