Supported IPMI Commands
ATCA-7368 Installation and Use (6806800M12C
)
100
The following table lists which boot properties can be configured and the corresponding boot
parameter number.
7.2.7.1.1 System Boot Options Parameter #96
This boot parameter is an Emerson-specific OEM boot parameter. Its definition is given in the
following table.
Table 7-8 Configurable System Boot Option Parameters
Configurable Boot Property
Corresponding Boot Parameter Number
Selection between default and backup boot flash as device
to boot from
Selection between default and backup EEPROM as device
where the on-board FPGA loads its configuration stream
from
96
POST Type
97
Timeout for graceful shutdown
98
BIOS boot parameters as defined in
100
Table 7-9 System Boot Options Parameter #96
Data Byte
Description
1
Bits 7..1: Reserved
Bit 0: Default/backup boot flash selection
0: Boot from default boot flash
1: Boot from backup boot flash
Note: the newly selected boot flash is connected to the
payload immediately, that means writing to the flash is
possible. Its image is executed after the next power-up or
cold reset of the payload.
The System Boot Options parameter #96 is non-volatile. During blade production, its data is
initialized to 0xFF and its state is set to invalid. Its parameter data remains preserved after IPMC
power cycles and firmware upgrades.
Summary of Contents for ATCA-7368
