Supported IPMI Commands
ATCA-7368 Installation and Use (6806800M12C)
113
7.4
Emerson Specific Commands
The Emerson IPMC supports several commands which are not defined in the IPMI or PICMG 3.0
specification but are introduced by Emerson: serial output commands.
7.4.1
Set/Get Feature Configuration
This command can be used to enable/disable features within the IPMC during runtime.
Before sending any of these commands, the shelf management software must check
whether the receiving IPMI controller supports Emerson specific IPMI commands by
using the IPMI command 'Get Device ID'. Sending Emerson specific commands to IPMI
controllers which do not support these IPMI commands will lead to no or undefined
results.
Proper handling of these commands is required to write a portable application.
Table 7-19 Set/Get Feature Configuration
Command Name
NetFn
(Request/Response)
CMD
Description
Set Feature Configuration
0x2E/0x2F
0x1E
Get Feature Configuration
0x2E/0x2F
0x1F
Summary of Contents for ATCA-7368
