DEUTSCH
ENGLISH
Rack PDUs Mounting Options
Index b
Seite / Page 40
(ECR no. 15302)
5
Knürr DI-STRIP
®
TriplePower
®
Knürr DI-STRIP
®
TriplePower
®
Montieren
Installation
1. Käfigmutter von hinten in den Lochraster in der Mitte des
PDU-Brackets einrasten (s. Abs. 5.2. - „Montieren”, Punkt 3)
1. Lock the cage nut from the back into the mounting holes in the
middle of PDU bracket (see par. 5.2. - “Installation”, point 3)
2. Das Gerät mittels zw ei Linsenschrauben am PDU-Bracket
befestigen
2. Attach the device to the PDU bracket using tw o lens head
screw s
Montage von zwei DI-STRIP TriplePower
®
nebeneinander
Installation of two DI-STRIP TriplePower
®
side by side
Notwendiges Werkzeug
– Phillips-Schraubendreher Nr. 2
– Gabelschlüssel Nr. 8
– Torx-Schraubendreher TX30
Tools required
– Phillips screw driver no. 2
– Open-end w rench no. 8
– Torx screw driver TX30
Anderes notwendige Montagezubehör
– Linsenschrauben FormZ M5x10 (Bestell-Nr. 05.041.330.9)
– Sperrzahnmuttern M5
Dieses Montagematerial gehört nicht zum Lieferumfang der PDU
und muss separat aus dem Katalog bestellt w erden.
Other necessary mounting hardware
– Lens head screw s formZ M5x10 (order no. 05.041.330.9)
– Serrated (toothed) locking nuts M5
This mounting hardw are is not included in the package w ith PDU
and must be ordered separately from the catalogue.
2,8 Nm
A
B
A
B