10
.....
Avocent® Matrix High Performance KVM Switching System
To access the serial menu:
1. Using a null modem cable, connect a terminal or a PC that is running terminal emulation
software to the Setup port on the back panel of the Matrix switch.
NOTE:
The terminal settings are 9600 bits per second (bps), 8 bits, 1 stop bit, no parity and no flow control.
2. Connect the other end of the serial cable to the serial port of your computer.
3. Launch the terminal emulation software.
4. Press any key to login.
5. Enter the username and password.
To navigate through the serial menu, type the number or letter that corresponds to the option you
wish to choose and press Enter. This action will bring you to a sub-menu or screen where you can
make configuration changes. To exit a menu or screen and to confirm any configuration changes
you have made, type
0
(zero) and press
Enter
.
Unit information
The unit information screen provides the following device information: EID, MAC address, Part
Number, Serial Number, Boot Version and App Version.
Network configuration
There are two network configuration options available for the Matrix switch, IPv4 or IPv6.
The following table describes the options for configuring IPv4.
Option
Description
Dynamic Host
Configuration
Protocol (DHCP)
The switch is a DHCP client and receives
all the network parameters from a DHCP
server on the network.
DHCP plus zeroconf
The switch attempts to obtain an IP
address using DHCP. If DHCP times out,
then it uses zeroconf to obtain an IP
address. Zeroconf picks an IP address out
of the block 169.254.0.0/16. To use
zeroconf the network must use the
169.254.0.0/16 block of IP addresses.
Zeroconf
The switch will immediately use zeroconf
to determine an IP address.
Static
The user will enter the IP address
manually.
IP Address
The IP address of the switch.
Netmask
The Netmask of the switch.
Default Gateway
The default gateway of the switch.
IPv4 Configuration
Summary of Contents for AVOCENT
