On-Board Web Interface
.....
25
Receiver – Attributes tab
The Attributes tab allows you to change the name, location and description of the receiver. Each
receiver within a system must have a unique name. The Location, Description and Notes fields are
optional, and are used only for your own information.
Receiver – Settings tab
From the Settings tab, you can change various settings for the receiver. The following table
describes the receiver settings.
Setting
Description
Auto Login
When enabled, a specified user is automatically
logged into the receiver whenever it is turned on and
physically connected to a switch in the system.
Auto Login Username
When Auto Login is enabled, this identifies the user
that will be logged in to the receiver.
Auto Connect
After a user logs into this receiver (either manually or
because of an auto login), the receiver will
automatically connect a KVM session to a specified
target.
Auto Connect Target
When Auto Connect is enabled, this identifies the
target to which the receiver will be automatically
connected.
Auto Connect Mode
When Auto Connect is enabled, this option
determines the mode (Shared or Private) that will be
used for the connection.
USB Mode
Determines what USB devices will be extended from
this receiver to a target.
LCD Backlight
Determines whether the LCD backlight will be on or
off.
Allowed Access
Determines the type of connections this receiver can
establish (Shared, Private or either).
Video Scaling
If enabled, the video will be scaled to match the
resolution of the attached monitor if the target is
outputting a different resolution.
Audio Output
Controls whether any audio output from the target is
used to drive the green audio output jack on the
receiver.
Microphone
Controls whether any signal from the pink
microphone jack on the receiver is sent over the KVM
session to the connected target.
Keyboard Auto Enumeration
If enabled, the keyboard will be re-enumerated when
connecting to a target.
Mouse Auto Enumeration
If enabled, the mouse will be re-enumerated when
connecting to a target.
Receiver Settings Descriptions
Summary of Contents for AVOCENT
