On-Board Web Interface
.....
27
Setting
Description
Wake on LAN MAC address
The MAC address to which the Wake on LAN signal should
be sent. Use MAC-48 or MAC-64 format such as
xx:xx:xx:xx:xx:xx or xx:xx:xx:xx:xx:xx:xx:xx, where each x is a
hexadecimal digit. You may also use hyphens instead of
colons, such as xx-xx-xx-xx-xx-xx.
USB Mode
Determines what USB devices will be extended to the
attached target by this transmitter.
LCD backlight
Determines whether the LCD backlight will be on or off.
Allowed access
Determines the type of connections that can be established
with this transmitter (Shared, Private or either).
Traffic priority
Determines whether USB or video traffic should be given
higher priority.
Audio output
Controls whether any audio output from the target,
connected to the green jack on the transmitter, will be sent
across the KVM session to the receiver.
Microphone input
Controls whether any microphone audio sent across the
KVM session will be passed on to the target via the pink jack
on the transmitter.
To edit the transmitter settings:
1. Select a transmitter from the list of devices.
2. Click on the Settings tab.
3. Change the desired settings.
4. Click
Save
.
Transmitter – Status tab
The Status of the transmitter including, the serial number, EID, status and port number are
displayed on the status tab.
Transmitter – Sessions tab
The Sessions tab for the transmitter displays all KVM sessions currently connected to the
transmitter.
Modes
There are three modes available for users connecting to transmitters and receivers. The modes
are Private only, Shared only and Private or Shared. The transmitter setting is the authority if there
is conflict in the user or receiver setting. For example, if the transmitter is set to private only and
user and/or receiver is set to shared only, the user will not be able to connect to the target. The
Private or Shared Mode is the default mode for devices.
Summary of Contents for AVOCENT
