Ceiling Fan Assembly
(continued)
5
emersonfans.com
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: CF810
CEILING
COVER
DOWNROD
HANGER
BALL
PIN
Figure 4
BLADE FLANGE
FAN BLADE
#10-32 x 1/4" SLOTTED
PHILLIPS WASHER HEAD
BLADE SCREW (3)
Figure 5
REMOVE SHIPPING
RETAINER AND SCREW (5)
BLADE
FLANGE
PREASSEMBLED 1/4-20 x 1/2"
PAN HEAD FLANGE SCREWS
WITH LOCKWASHERS (2 per
blade assembly)
SWITCH HOUSING
PLATE
Figure 6
5.
Reinstall the hanger ball (Figure 4) on the downrod
as follows. Route the three 80” motor leads through
the hanger ball. Position the pin through the two
holes in the downrod and align the hanger ball so the
pin is captured in the groove in the top of the hanger
ball. Pull the hanger ball up tight against the pin and
securely tighten the setscrew in the hanger ball. A
loose setscrew could create fan wobble.
6.
The fan comes with blue, black and white leads that
are 80-inches long. Before installing the fan,
measure up approximately 6 to 9-inches above top
of hanger ball/downrod assembly. Cut off excess
leads and strip back insulation 1/2-inch from end of
leads.
7.
Mount blade flange to fan blade using three
#10-32 x 1/4” slotted Phillips washers head screws
(Figure 5).
8.
Repeat this procedure for the remaining four blades
and flanges.
9.
Turn the fan assembly upside down in preparation
for mounting the fan blade assemblies.
NOTE: Take care not to scratch fan housing when
installing blades.
10.
Carefully unscrew the five shipping retainers from
the motor housing. Discard the five screws and
shipping retainers (Figure 6).
11.
Attach the blade assembly to the motor hub using
the two 1/4-20 x 1/2” pan head flange screws with
lockwashers in flange. Make sure the screws are
tightened securely (Figure 6).
12.
Repeat this procedure for the other four blade
assemblies.
13.
Engage the keyholes of the switch housing cover
plate by rotating the switch housing cover plate
clockwise on the switch adapter (Figure 7).
14.
Install the switch housing cover plate by using the
three #8-32 x 3/8” screws (supplied in the parts
bag) (Figure 7).
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened. Failure
to verify that the pin and setscrew are properly
installed could result in the fan falling.
WARNING
!
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not insert
foreign objects in between rotating fan blades.
WARNING
!
SWITCH
ADAPTER
SCREWS (3)
SWITCH HOUSING
COVER PLATE
Figure 7
