CEILING
FLOOR
AT LEAST
7'
Figure 15
The fan must be hung with at least 7' of clearance from
floor to blades (Figure 15).
WARNING
!
To avoid possible fire or shock, do not pinch wires
between the hanger ball/downrod assembly and
hanger bracket.
WARNING
!
The outlet box and joist must be securely mounted and
capable of supporting at least 50 lbs. Use only a U.L.
outlet box listed as “Acceptable for Fan Support of
22.7 kg. (50 lbs.) or less”.
WARNING
!
Failure to seat anti-rotation tab in groove could cause
damage to electrical wires and possible shock or fire
hazard.
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked “Acceptable for
Fan Support of 22.7 kg. (50 lbs.) or less”, and use
screws supplied with outlet box. Most outlet boxes
commonly used for support of light fixtures are not
acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
WARNING
!
4.1
Securely attach the hanger bracket to the outlet box
using the two screws supplied with the outlet box.
(Figure 16.)
NOTE: Sloped Ceiling Installation- The hanger
bracket supplied with this fan can accommodate a
35 degree (8:12) pitch ceiling. The hanger ball
opening must be positioned to face up towards the
peak of the ceiling (Figure 19).
Hanger bracket must seat firmly against outlet box. If
the outlet box is recessed, remove wall board until
bracket contacts box. If bracket and/or outlet box are
not securely attached, the fan could wobble or fall.
WARNING
!
TWO SCREWS
SUPPLIED WITH
OUTLET BOX
HANGER BRACKET
ANTI-ROTATION TAB
OUTLET
BOX
HANGER
OPENING
Figure 16
OUTLET
BOX
HANGER
BRACKET
HANGER BALL/
DOWNROD
ASSEMBLY
NOTE: CEILING COVER, SUPPLY WIRES AND FAN WIRES OMITTED
FOR CLARITY.
Figure 17
4. How to Hang Your Ceiling Fan
11
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF995
4.2
Carefully lift the fan and seat the hanger ball/
downrod assembly into the hanger bracket that was just
attached to the outlet box (Figure 17). Be sure the
groove in the ball is lined up with anti-rotation tab on
the hanger bracket (Figure 16).
