2 2
NAP Timer (Buzzer Alarm Only)
This model features a programmable 99-minute Nap Timer that can be used to
wake you after naps of up to 99 minutes without disturbing your regular alarm
settings.
Depress and hold the
NAP
button on the top panel.
The display shows
“n:30”
, indicating that the buzzer
alarm will sound in 30 minutes, and the
NAP
indicator
appears in the display.
To adjust the length of the Nap Timer continue holding the
NAP
button and depress
the
SKIP FWD.
or
SKIP REV.
buttons on the front panel until the display
shows the desired Nap Timer length.
At the selected Nap time the buzzer will sound. It will start softly and gradually
increase in volume to wake you up. The buzzer alarm will continue for one hour
and then shut off automatically.
To stop the buzzer sound sooner press the
SNOOZE
or
POWER ON/OFF
button
on the top panel.
Note:
When you change the Nap Timer setting, your new setting becomes the default
setting.
For example if you change the Nap Timer setting from 30 minutes to 45 minutes,
each time you press the
NAP
button the buzzer will sound after 45 minutes.
(
Exception
: If you have a power failure and there is no back up battery installed,
or the back up battery is dead, the Nap Timer will return to the original 30
minute default setting when the power is restored.
)
Display DIMMER
This model was shipped with the
DIMMER
switch set to the
HI
(High) position for
maximum display brightness. If you feel that the display is too bright for sleeping,
set the
DIMMER
switch to the
LO
(Low) position.
NAP
CKD3630_060404.p65
4/6/2004, 15:19
22
