1 Introduction
The Scroll compressor has been under development at Copeland since 1979 and is the most efficient and durable
compressor Copeland has ever developed for air-conditioning and refrigeration. Copeland has now invested
significant resources and carried out extensive testing to optimize a completely new range of ZH Scroll compressors
for dedicated Heat Pump applications. It offers very low vibration and sound levels and is tolerant to stresses caused
by liquid slugging, flooded starts, and debris commonly found in refrigeration systems. Available product range in this
family is from 2 to 6 hp. For detailed information, please, refer to the Copeland Selection Software accessible from the
Copeland website at www.ecopeland.com.
These guidelines are not meant to replace the system expertise available from system manufacturers.
2 Safety
Instructions
Only qualified personnel should install and repair COPELAND compressors.
•
Refrigerant compressors must be employed only for the use they are made for.
•
Only approved refrigerant and refrigerating oils must be used.
•
Do not start the compressor until it is charged with refrigerant.
•
Correctly used, the compressor and the pressure line piping may reach temperatures that may
cause burning if touched.
•
Wear safety goggles when working on open systems.
•
If the refrigerant needs to be removed from the system, do not disperse it in the environment,
use the correct equipment & method of removal.
•
For storage, use original packaging and avoid collisions and tilting.
•
Trained electrical personnel must connect the compressor and its accessories.
•
All valid standards for connecting electrical and refrigeration equipment must be observed.
•
Limit values for the supply voltage of the unit may not be exceeded.
It is not allowed to run a test without the compressor being connected to the system and without
refrigerant. It is of vital importance that the discharge stop valve has been fully opened before the
compressor is started. If the discharge stop valve is closed or partly closed an unacceptable pressure
with accordingly high temperatures may develop. When operating with air the so-called diesel effect
may occur, i.e. the air sucked in is mixed with oil gas and can explode due to the high temperature,
and thereby destroy the compressor.
C6.2.9/0203-1004/E 2