6
U.L. Model No.: CF411
3. Ceiling Fan Assembly
(Continued)
COUPLER
COVER
GROMMET
MOTOR
HOUSING
DOWNROD
Figure 5
3.5
Make sure the Grommet is properly installed in the Coupler
Cover, then slide the Coupler Cover on the Downrod until it
rests on the Motor Housing (Figure 5).
CLEVIS
PIN
MOTOR
COUPLER
HAIRPIN
CLIP
CLEVIS
PIN
RETIGHTEN
PHILLIPS HEAD
SET SCREWS (2)
HAIRPIN
CLIP
Figure 4
DOWNROD
CEILING COVER
PIN
HANGERBALL
SET SCREW
Figure 6
3.6
Place the Ceiling Cover over the Downrod.
Then reinstall the Hanger Ball (Figure 6) on the Downrod
as follows.
Route the three 80” Motor Wires through the Hanger Ball
and slide the Hanger Ball over the Downrod.
Position the Pin through the two holes in the Downrod and
align the Hanger Ball so the Pin is captured in the groove
in the top of the Hanger Ball.
Pull the Hanger Ball up tight against the Pin and securely
tighten the Set Screw in the Hanger Ball.
A loose Set Screw could create fan wobble.
3.4
Align the Clevis Pin holes in the Downrod with the holes in
the Motor Coupler.
Install the Clevis Pin and secure with the Hairpin Clip
(Figure 4).
The Clevis Pin must go through the holes in the Motor
Coupler. It is critical that the Clevis Pin in the Motor
Coupler is properly installed and securely tightened.
Retighten the two Phillips Head Set Screws to secure the
Downrod to the Motor (Figure 4).
It is critical that the clevis pin and set screws in the motor
coupler are properly installed and securely tightened.
Failure to verify that the pin and set screws are properly
installed could result in the fan falling.
WARNING
!
