NOTE: If you are using an Emerson Light Fixture
with your fan, refer to the Light Fixture Owner’s
Manual for installation instructions.
8
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box
and not pinched between the ceiling cover and the
ceiling.
WARNING
!
GROUND
BLACK
TO AC
ELECTRICAL
SUPPLY
WHITE
GREEN
REMOTE CONTROL
RECEIVER
BLACK/WHITE
WHITE
BLUE
WHITE
BLACK
YELLOW
BLUE
WHITE
BLACK
ORANGE
Figure 14
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until blades are in place. Noise and fan
damage could result.
WARNING
!
1-1/4"
THREADED
STUD
LOCKWASHERS (2)
CEILING COVER
KNURLED KNOB
Figure 16
3. Using wire connectors (supplied), make wiring
connections as follows (Figure 13 and 14):
a. Connect the green ground wires from the
hanger bracket and the hanger ball to the supply
ground wire (bare or green).
b. Connect the white fan wire and the white
supply wire to the white receiver wire (AC
IN/MOTOR N).
c. Connect the black fan wire to the black
receiver wire (TO MOTOR L).
d. Connect the black supply wire to the
black/white receiver wire (AC IN L).
e. Connect the blue fan wire to the blue receiver
wire (BOTTOM LIGHT).
f. Connect the orange fan wire to the yellow
receiver wire (UPPER LIGHT).
g. After connecting the wires, spread them apart
so that the green and white wires are on one side
of the outlet box and the black wire is on the
other side. Make sure that black antenna wire sits
on top of the receiver unit.
OUTLET BOX
BLACK SUPPLY WIRE
BLACK/WHITE RECEIVER WIRE
BLACK FAN WIRE
BLUE FAN WIRE
BLUE RECEIVER
WIRE
ORANGE FAN WIRE
YELLOW RECEIVER WIRE
CEILING COVER
WHITE RECEIVER WIRE
WHITE FAN WIRE
WIRE CONNECTOR
RECEIVER
WHITE SUPPLY
WIRE
SUPPLY
GROUND
WIRE (GREEN
OR BARE)
HANGER BALL
GROUND WIRE
(GREEN)
HANGER BRACKET
GROUND WIRE
(GREEN)
HANGER BRACKET
BLACK RECEIVER WIRE
OPEN
PORTION OF
RECEIVER
HERE
Figure 13
4. Insert the connected ends of the wires
up through the open side of the hanger
bracket and into the outlet box as
shown in Figure 15.
5. Screw two 1-1/4” threaded studs (sup-
plied with the ceiling fan) into the tapped
holes in the hanger bracket (Figure 15).
OUTLET BOX
RECEIVER
CEILING COVER
HANGER
BRACKET
1-1/4"
THREADED
STUDS (2)
Figure 15
6. Slide the receiver up and over the hanger bracket.
Press the receiver against the ceiling, holding it in
place while installing the ceiling cover. Lift the
ceiling cover up to the threaded studs and turn until
studs protrude through the holes in the ceiling
cover (Figure 16).
7. Secure the ceiling cover in place by sliding lock-
washers over the threaded studs and installing the two
knurled knobs (supplied) (Figure 16). Tighten the
knurled knobs securely until the ceiling cover fits
snugly against the ceiling. Your fan is now wired to be
controlled using the remote control transmitter.
