Tools Needed for Assembly
One Phillips head screwdriver
One stepladder
One wire stripper
Two wire connectors (supplied)
MATERIALS
Wiring, outlet box and box connectors must be of type
required by the local code. The minimum wire would
be a 3-conductor (2-wire with ground) of the following
sizes:
Unpacking Instructions
For your convenience, check-off boxes are provided next to each step. As each step is
completed, place a check mark in the box. This will insure that all steps have been
completed and will be helpful in finding your place should you be interrupted.
1. Check to see that you have received the following parts:
NOTE: If you are uncertain of part description,
refer to exploded view illustration.
a. Fan motor assembly
b. One switch housing assembly
c. Five fan blades
d. One ceiling cover
e. Five blade flanges
f. One hanger ball/downrod assembly
g. One hanger bracket
h. One coupling cover
i. One loose parts bag containing:
1. Sixteen M5 x 6mm slotted Phillips
washer head blade screws
2. One M6 x 14mm Phillips head screw with
lockwasher
3. One wood pendant (large)
4. One wood pendant (small)
5. Two couplings
6. Three wire connectors
7. Two threaded studs
8. Two lockwashers
9. Two knurled knobs
10. One clevis pin
11. One hairpin clip
3
NOTE: Place the parts from the loose parts bags
in a small container to keep them from being lost.
If any parts are missing, contact your local
retailer or catalog outlet for replacement before
proceeding.
2. Remove the fan motor assembly from the
protective plastic bag. Place the fan assembly into
the upper foam pad with the top of the motor
facing up.
The upper foam pad serves as a holder for the fan
during the first stages of assembly.
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 5). If you feel
you do not have enough wiring knowledge or experi-
ence, have your fan installed by a licensed electrician.
WARNING
!
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Company. Substitution of parts or
accessories not designated for use with this product
by Emerson Company could result in personal injury
or property damage.
WARNING
!
WARNING
!
This Manual Is Designed to Make it as Easy as Possible for You to
Assemble, Install, Operate and Maintain Your Ceiling Fan
Installed Wire Length
Wire Size A.W.G.
Up to 50 ft.
14
50-100 ft.
12
FAN BLADES
CEILING
COVER
SWITCH
HOUSING
ASSEMBLY
LOOSE
PARTS BAG
FAN BLADES
FLANGES
HANGER
BRACKET
HANGER BALL/
DOWNROD
ASSEMBLY
COUPLING
COVER
MOTOR
ASSEMBLY
