Reassembly
1.
Grease the O-ring seals (14) and B port seals (16) according to step 9.1.
2.
Ensure that O-ring seals (14) and B port seals are kept in place during assembly.
3.
Place the spring cartridges in actuator as per required spring set (see Figure 29).
4.
Tighten each end cap screw in small equal turns and in the sequence as per Figure
28. Refer to Table 13 for the correct torque. We recommend to use some grease on
the screws for easier fastening.
Figure 30
Spring-return end cap assembly
3
1
4
2
2
14
16
2
10
14
10
Installation, Operation and Maintenance Manual
DOC.IOM.EF.EN Rev. 6
September 2015
37
Section 9: Reassembly
Summary of Contents for EL-O-Matic F-Series
Page 2: ......
