7
OPERATING INSTRUCTIONS
NORMAL PLAYBACK
NOTE:
Although this CD player can read CD-R and
CD-RW discs, in addition to normal CDs, the playability
of CD-R and CD-RW discs may be effected by the
type of software that was used to create the discs, as
well as the quality and condition of the blank media
you are using. 100% playability cannot be guaranteed.
This is not an indication of a problem with the player.
1.) Connect the headphones to the PHONES jack.
Set the VOLUME control to a low level before
you begin playback and then adjust the volume
to a comfortable level after playback begins.
2.) Slide the CD Door OPEN switch to the right to
release the lock and open the CD Door.
3.) Place your disc on the center spindle with the
printed label side facing up. Press down gently
near the center hole to make sure the disc is
properly seated on the spindle.
4.) Close the door completely until it locks shut.
5.) Press the PLAY/PAUSE
button to begin
playback on Track 1. Joggable indicator flashes
and the playing time shows in the display.
6.) Adjust the VOLUME and DBBS (Bass Boost)
controls as desired.
7.) When all tracks have been played the player stops
and the display shows the total tracks and playing
time on the disc. After approximately 1 minute the
power shuts off and the display goes blank.
To stop playback before the disc ends press the
STOP button at any time. Press the STOP
button again to shut the power off immediately.
8.) Slide the CD Door OPEN switch to the right to
open the door and remove your disc. Close the
CD Door and return your disc to its protective
storage case.
ON DBBS OFF
VOLUME
PLAY/PAUSE
STOP
OPEN
To PHONES Jack
HD7096A_7099A_071403.p65
14/7/2003, 10:34
7
