1
E N G L I S H
Installing Bio-Charge
®
Bottle
Use only InSinkErator
®
Bio-Charge
®
septic assist bottles. Do not squeeze the Bio-Charge
®
Bottle; squeezing the bottle may cause Bio-Charge
®
to
discharge and spill.
• Unscrew Bio-Charge
®
dispenser cap nozzle counterclockwise until nozzle pops upward to dispensing position. Do not remove dispenser cap
nozzle.
• Align bottle with concave side toward disposer.
IMPORTANT:
Press septic assist bottle firmly into place. The bottle
MUST
be seated into the
dispose housing for proper operation; there
SHOULD NOT
be a gap. (When installed correctly, the button on the disposer housing will be
fully ejected.
• Release button. Pull bottle down slightly to ensure it is engaged.
Replacing Bio-Charge
®
Bottle
To keep your septic system operating at peak efficiency, replace the Bio-Charge
®
bottle when it is empty.
• Make sure disposer is off.
• Press button on disposer just above bottle and pull bottle down to remove it. (Do not refill or reuse empty bottle.)
INSTALLING AND REPLACING THE BIO-CHARGE
®
BOTTLE
