Installation
9
Position Rails on 700mm and 800mm Cabinets
1.
Determine the proper location of the rails.
2.
Remove center support by loosening the two quick-release mechanical fasteners.
Repeat for other side of the EIA rail frame (see Figure 7).
3.
Loosen the four screws that secure the node brackets to the bottom frame member.
Repeat on the other side of EIA rail frame.
4.
Loosen the three screws that secure the top EIA rails support bracket to the top frame member.
Repeat on the other side of the EIA rail frame.
5.
Slide the rails to their new location. The rails will bind if they are not kept at a right angle to the
frame.
6.
Tighten all hardware and reinstall the quick-release mechanical fasteners.
Figure 7
Vertical rail repositioning—700 and 800mm cabinets
Screws in
T-Slot in
frame at
bottom of
cabinet
Rail attached
to cross brace
at top left
corner
Screws in
T-slot in
frame
Screws (2) in T-Slot
in Frame
Screw in T-Slot in face of
aluminum frame at
bottom of cabinet. (There
are two screws, one on
each side of the node.)
Quarter-Turn Fastener;
fastener on the
innerface of the vertical
rail secures the vertical
rail to the bracket
