15
EN
W
ATCHING TV
WATCHING TV
INTRODUCTION
PREPARATION
INITIAL SETTING
OPTIONAL SETTING
TROUBLESHOOTING
INFORMATION
Channel Selection
Select channels by pressing
[CH
K
/
L
]
or
[the Number buttons]
.
To select the memorized channels, use
[CH
K
/
L
]
or
[the Number buttons]
.
To select the non-memorized channels, use
[the Number buttons]
.
To Use [the Number buttons]
TV
When selecting analog channel 12
DTV
When selecting digital channel 12-1
Be sure to press
[–]
before entering the minor
channel number.
Press
[CH. RECALL]
to return to the previously
viewed channel.
About digital TV broadcasting:
With its high definition broadcast, digital broadcasting
far surpasses analog broadcasting in both its picture
and sound quality.
What is the minor channel?
By using high compression technology, digital
broadcasting offers a service that enables multiple
signals to send simultaneously.
Therefore, you can select more than one program per
major channel since digital broadcasting technology
distinguishes between multiple channels broadcast by
a single network.
18:00
18:30
19:00
19:30
20:00
20:30
Note:
• “No Signal” will appear on the TV screen after the minor
channel broadcast is over.
• “Audio only program“ message will appear on the TV
screen, when you receive only sound signal.
5
•
•
-
-
•
Volume Adjustment
This section describes how to adjust the volume. The mute function, which
turns the sound off and on, is also described.
Use
[VOL.
X
/
Y
]
to adjust the audio volume.
Volume
20
The volume bar will be displayed at the bottom of
the TV screen when adjusting the volume.
The volume bar will automatically disappear in a few
seconds.
Press
[MUTE ]
to turn off and on the sound.
Mute
“Mute” is displayed on the TV screen for a few
seconds.
Press
[MUTE ]
again or
[VOL.
X
/
Y
]
to recover the
original volume.
Sleep Timer
The sleep timer can be set to automatically turn off the unit after an
incremental period of time.
1
Press
[SLEEP]
to set the sleep timer.
Sleep
Off
Sleep timer display appears on the TV screen.
2
Press
[SLEEP]
repeatedly to change the amount of time
until shut off.
Sleep
120min.
You can set your unit to turn off after a set period of
time (from 30 to 120 minutes).
Each press of
[SLEEP]
will increase the time by 30
minutes.
After setup, the sleep timer display can be called up
for checking by pressing
[SLEEP]
.
To Cancel the Sleep Timer
Press
[SLEEP]
repeatedly until “Sleep Off” is displayed
on the TV screen.
Note:
• The sleep timer display will automatically disappear in a
few seconds.
• When you disconnect the unit from the AC outlet or when
a power failure occurs, the sleep timer setting will be
canceled.
5
•
•
•
5
•
•
•
•
NTSC (analog mode) [Air Time]
ATSC (digital mode)
major channel
minor channel
: change automatically
: change manually by using
[CH
K
/
L
]
CH4
CH4
CH4
CH4
CH4
No signal No signal
No signal
CH4-1
CH4-2
CH4-2
No signal
CH4
(high definition TV)
CH4-1
Summary of Contents for LC320EM9 3
Page 35: ...35 EN MEMO ...
Page 71: ...35 ES MEMO ...
