Equipment Inspection and Startup
23
2.0
E
QUIPMENT
I
NSPECTION
AND
S
TARTUP
2.1
Internal Inspection
A detailed internal inspection
should be performed after the unit is in place and before it is ener-
gized, to ensure trouble free startup. The same internal inspection should be carried out when per-
forming preventive maintenance.
Open the unit
- Gain access to the internal components of the Liebert FPC unit by removing the
exterior panels and internal accent panels.
Visually inspect
- Be sure wiring and components are not damaged.
Check power connections
- Check
all
power connections for tightness. Refer to
Tables 11
through
14
for torque requirements of all electrical connections.
Perform formal detailed inspection
- Follow the procedures described in
3.0 - Inspection and
Start-Up Checklist
when performing detailed inspection.
2.2
Startup
Checklists
Follow the detailed step-by-step checklist (
3.0 - Inspection and Startup Checklist
) when installing
and starting up the Liebert FPC.
Initial System Startup
A qualified electrician must be employed to perform the equipment inspection and startup. Liebert
system startup may be arranged by calling your local Liebert sales representative or Liebert Global
Services. In the United States, call 1-800-LIEBERT.
Warranty
A copy of the appropriate checklist (furnished with the equipment) must be completed, signed, dated
and returned to Liebert Corporation. Warranty coverage of the equipment is not effective unless the
checklist has been received by the factory.
!
WARNING
Verify that all incoming line voltage (power) and low-voltage (control) circuits are
de-energized and locked out before performing the internal inspection.
!
WARNING
Equipment inspection and startup should be performed only by trained personnel. Hazardous
voltages are present during startup procedures.
Electrical safety precautions must be followed throughout inspection and startup.
