Emerson Liebert MicroPOD MP2-210K, User Manual

Installation

4

4.0

I

NSTALLATION

4.1

Installation on a Liebert GXT UPS

1. Unpack the Liebert MicroPOD carefully, noting the packing method. Retain the box and packing 

material for possible future shipments.

2. Inspect the Liebert MicroPOD for freight damage. Report any damage to the carrier and your 

local dealer or Liebert representative.

3. Verify that the Liebert MicroPOD input cord, UPS input cord and receptacle for the UPS have the 

same type of configuration.

4. If you already have a UPS installed, turn off all connected loads and unplug them from the UPS. 

Turn off the UPS and disconnect the input cord.

5. Attach the two Liebert MicroPOD securing brackets (optional for Liebert GXT series UPS) to the 

rear of the UPS (see top of 

Figure 4

). You will need a long M3 Phillips head screwdriver for this 

procedure (the torque is 7 in-lb, or 0.79 Nm). The Liebert MicroPOD brackets have a hole to allow 

the screwdriver to reach the screw. 

6. Next attach the Liebert MicroPOD to the securing brackets (see 

Figure 4

). The Liebert 

MicroPOD can be installed to face one of three different directions utilizing the same mounting 

procedures.

Figure 4

Attaching Liebert MicroPOD to the UPS with securing brackets

NOTE

This manual provides instructions for the Liebert MicroPOD only. Refer to your UPS manual 

for UPS operation and installation instructions.

Step 5 - Attach brackets 

to rear of UPS

Step 6 - Attach Liebert 

MicroPOD to brackets

Liebert 

MicroPOD

UPS