141
User Manual
UM6C55C (P7000597)
Lorain Power System (AP6C55CA/CB)
Standard 10.00 (March 2008)
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
6. Communicating with System
Manager CIP
6.1. General
The remote GUI of System Manager CIP can be accessed remotely in three
ways:
•
using a computer equipped with a web browser and connected locally
into the RJ45 Ethernet port through a cross-over Ethernet cable
(optional - A7000827),
•
using a computer equipped with a web browser and connected
remotely through a LAN or WAN network connection into the RJ45
Ethernet port (straight cable required), or
•
using a computer equipped with a web browser and connected
remotely through a dial-up network connection into the RS-232 port
via an external modem.
Note:
If you do not have experience with computer communication,
before attempting to carry out the instructions contained in this Chapter,
contact your information system or network expert to make sure your PC is
connected to the System Manager CIP with the proper cables and that the
communication parameters have been properly configured.
6.2. Recommended PC requirements
Your PC must meet the following minimum requirements to allow you to
remotely connect to the System Manager CIP.
•
Hardware:
Processor – Pentium 120 MHz or higher,
32 MB of RAM or better,
Network card, and
Network cable with switched connector.
•
Software:
Operating system - Windows 95 or later, and
Netscape Navigator 4.0 or later, or
Internet Explorer 4.0 version 4.72 or later.
Summary of Contents for Lorain CIP 48120 AP6C55CA
Page 2: ......
