20
Introduction
UM6C55C (P7000597)
User Manual
Standard 10.00 (March 2008)
Lorain Power System (AP6C55CA/CB)
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
controllers, such as high and low voltage alarms, battery on discharge alarm,
fuse and circuit breaker alarms, rectifier failure alarms, boost charge, load
low voltage disconnect (LLVD) or battery low voltage disconnect (BLVD),
temperature compensation, etc.
The System Manager CIP, in addition to all of the Controller CIP’s functions,
provides advanced features such as configurable input/output ports, a
graphical display, a charge control function, a built-in web server, etc.
The Lorain CIP
power system utilizes 750 W or 1500 W rectifiers connected
in parallel as building blocks to reach the maximum charging capacity of 60
A or 120 A. The rectifiers operate from a 110/120 or 208/240 V single-phase
50/60 Hz AC source. The controller automatically sets all the operational
parameters of the rectifiers in the system as these are inserted (plugged-in).
Should the controller fail or be removed from the system, the rectifiers then
revert to the factory default value of 52.1 V.
2.1.2.
Lorain CIP Access Power Systems
The Lorain CIP
Access power system is a dual-shelf integrated –48 V dc
power system. The AP5C55BF Lorain CIP Access power shelf has a load
capacity of 45A (N+1 configuration) or 60A and a charging capacity of 60A
when using the 750W rectifier at 48V, or 90A (N+1 configuration) or 120A
and a charging capacity of 120A when using the 1500W rectifier at 48V. The
system is front access and designed to be used in embedded applications, with
or without batteries.
Note:
This equipment is designed to be connected to a battery source of
nominal 48 V dc based on 2 V per cell with no specified minimum
resistance.
For the AP5C55BF Lorain CIP Access, the system may consist of two
shelves, each equipped with mounting brackets for standard 23” mounting
and a front projection of 5”.
•
AP5C55BF power shelf (lower position):
The AP5C55BF power shelf incorporates a microprocessor-based
controller, up to four 750 W plug-in rectifiers, an optional battery
low voltage disconnect (BLVD) section, a connection interface on
the right side for the batteries and the Ring & Distribution Module,
and a connection interface on the left side for the AC supply for the
rectifiers. It can provide up to 45 A (N+1) of discharge load capacity
when operated from a single-phase 110/120 V ac 50/60 Hz source if
using the 750W rectifier or 90A (N+1) of discharge load capacity
when operated from a single-phase 208/240 V ac 50/60 Hz source if
using the 1500W rectifier.
In addition to the above equipment, the AP5C55BF power shelf may
also incorporate an optional battery low voltage disconnect (BLVD)
or load low voltage disconnect (LLVD) contactor.
Summary of Contents for Lorain CIP 48120 AP6C55CA
Page 2: ......
