Configuring and operating the system
55
User Manual
UM6C55C (P7000597)
Lorain Power System (AP6C55CA/CB)
Standard 10.00 (March 2008)
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
connector J3 in the controller connection interface card located behind the
hinged front cover, as illustrated in Figure 5.2.
Figure 5.2 – Connector definition in the controller connection interface card
5.3.5.
Clearing of alarms
Refer to the “Troubleshooting” section of the “Maintenance” Chapter for the
instructions on how to clear alarms.
Note 1:
If a module has been removed from the system and an alarm
associated with this module still appears on the Controller CIP, this alarm
must be cleared to erase it and reset the list of alarms. After the reset,
ongoing alarm conditions on active modules will still appear on the
Controller CIP, but any alarms associated with removed modules will no
longer be displayed. To do an alarm reset, press and hold the “Refresh”
button for 5 seconds.
Note 2:
The Major output relay operates in the safe mode; it is activated
when there are no alarm conditions and released when there is one or more
alarm condition(s).
Summary of Contents for Lorain CIP 48120 AP6C55CA
Page 2: ......
