Configuring and operating the system
57
User Manual
UM6C55C (P7000597)
Lorain Power System (AP6C55CA/CB)
Standard 10.00 (March 2008)
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
Note:
To enable the temperature compensation function of the System
Manager CIP, a battery temperature probe located on the battery
must
be
connected to the TB1 terminal block located behind the front door of the
controller and distribution section (see Figure 3.13 and Figure 3.15). An
optional ambient temperature probe may also be connected to the
“Ambient temp. probe” connector of the System Manager CIP shown in
the above illustration. This probe is not required to enable the temperature
compensation function, but it provides an “Ambient Temperature” alarm.
Figure 5.4 – Connector definition in the controller connection interface box
5.5. Local access to the System Manager CIP
The System Manager CIP are accessible directly by means of the four push
buttons located below the screen and the screen itself. Refer to Figure 3.11.
5.5.1. Initial
start-up
When the System Manager CIP is started for the first time, after going
through the initialization routine, it displays the default screen illustrated in
Figure 5.5.
Summary of Contents for Lorain CIP 48120 AP6C55CA
Page 2: ......
