NELSON
™
INSTALLATION
AXPTC125 POWER TEE SPLICE CONNECTION KIT
INSTRUCTIONS
TULSA, OK 74146
TEL 918-627-5530
FAX 918-641-7336
www.nelsonheaters.com
GA-5052 Rev. 3 DRAFT
Sheet 3 of 10
August 2017
Lightly cut around the cable outer jacket and up
the center.
Bend cable to break outer jacket.
Remove outer jacket from heating cable.
Push braid back to create a bulge.
At the bulge, separate the braid to make
an opening.
Bend heating cable at opening and pull
the cable through.
Lightly cut around the cable inner jacket.
Cut up the middle of the inner jacket.
Bend cable to break inner jacket and remove.
Shave the core material from the outside of each
bus wire.
6” (152 mm)
7” (178 mm)
Do Not Cut Braid
Do Not Cut or
Nick Bus Wires
HEATING CABLE PREPARATION
3
Notch core material approximately ¼” (6 mm) for
the end of the heating cable.
Peel both bus wires from core material.
2
4
5
6
7
8
9
10
1
WARNING
WARNING
