Error Codes
If the screen on the unit displays "AS", the room temperature sensor has failed.
Contact your authorized EMERSON QUIET K00L Service Center.
If the screen on the unit displays "ES", the pipe temperature sensor has failed.
Contact your authorized EMERSON QUIET K00L Service Center.
If the screen on the unit displays "P1", the water collection tank inside the unit may be full.
Refer to the "Drainage Instructions" on Page 16 for instructions on draining excessive water.
If error repeats, contact your authorized EMERSON QUIET KOOL Service Center.
INSTALLATION INSTRUCTIONS
PREPARING FOR INSTALLATION
EXHAUSTING HOT AIR
In the Cool Mode, the air conditioning must be placed close to a
window opening so that the warm exhaust air can be ducted
outside.
First position unit on a flat floor and make sure there's a
minimum of 12" clearance around the unit, and the unit is within
the vicinity of a single circuit outlet power source.
1. Extend either side of the hose (Fig.1) and screw the hose to
connector A (Fig.2).
2. Extend the other side of the hose and screw it to connector B
(Fig.3).
3. Install the connector B into the unit (Fig.4).
4. Affix the connector A into the window slider kit and seal.
(Fig.5 & 6)
