RXi2-UP IPC Hardware Reference Manual
Section 5
GFK-3047D
Oct 2021
Installation and Startup
29
5.6
Initial Startup
A few seconds after powering up, the RXi2-UP IPC system BIOS banner displays on the
screen. If you do not see any error messages up to this point, the RXi2-UP IPC is running
properly and ready to be configured for your application.
5.7
UEFI Firmware Setup
5.7.1
Entering UEFI Firmware Setup
To enter setup during the initial startup sequence: press the Delete or F2 key during the
startup sequence.
Adhere to the applicable on-screen messages when prompted.
To save changes, go to Save & Exit page and choose Save Changes and Exit option
5.7.2
Selective Alternative Boot Source
To select an alternative boot device (for example, boot from USB stick), without changing
settings in UEFI Firmware, please press and hold the F7 key during the power-up sequence
5.7.3
Setting up Boot Priority
To configure a particular boot priority, within UEFI Firmware Setup, navigate to the Boot
page and configure Boot Option #1 and Boot Option #2, as required. Go to Save & Exit
page and choose Save Changes and Exit option.
5.7.4
Restoring UEFI Settings
When within UEFI Firmware Setup, navigate to the Save & Exit page, choose Restore
Defaults, choose Save Changes and Exit.
5.7.5
UEFI Passwords
To configure Administrator and User passwords, within UEFI Firmware Setup, navigate to
Advanced page, choose Security, make required changes. Go to Save & Exit page and
choose Save Changes and Exit option
5.7.6
Secure Boot Configuration
To configure Secure Boot, change/reset Keys, within UEFI Firmware Setup, navigate to the
Advanced page, choose the Secure Boot option, make required changes. Go to Save & Exit
page and choose Save Changes and Exit option
Note: If the RXi2-UP IPC does not perform as described, some damage may have occurred
during shipment or the board is not installed or configured properly. Contact Emerson for
technical support. (Refer to the section Contact Information.)
