32
2/4 PORT SECURE KM: SCKM120; SCKM140; SCKM145
SCKM120; SCKM140; SCKM145
SM80NU-3 SM80NU-3 SM80NU-3
Section 5 - Troubleshooting
Troubleshooting Guide
General
Problem:
As product powers-up all
channel-select LEDs are
turned
ON and then OFF. After that a specific, predefined LED
combination is turned ON. Product is inoperable.
Solution:
The product did not pass self-test procedure. Try to power
cycle product. If problem persists please contact your system
administrator or our technical support.
Problem:
No power, none of the front panel LEDs are illuminating.
Solutions:
Check AC or DC power connection to make sure product receives
power properly. Replace cable or power supply if needed. If
problem persists, contact your system administrator or our
technical support.
Problem:
Product enclosure appears disrupted or all channel-
select LEDs flash continuously
.
Solution:
The product may have been tampered with.
Please
remove product from service immediately and contact
Technical Support.
Important Security Note:
If you are aware of potential security vulnerability while installing or
operating this product, we encourage you to contact us immediately in
one of the following ways:
Web form:
http://www.emersonnetworkpower.com/en-
US/Support/Technical-Support/KVM/Pages/default.aspx
AvocentSecurityFLR@emerson.com
Tel: +1-888-793-8763
Important:
If the unit’s enclosure appears disrupted or if all LEDs flash
continuously, please remove product from service immediately and
contact Technical Support at
http://www.emersonnetworkpower.com/en-US/Support/Technical-
Support/KVM/Pages/default.aspx
Important:
This product is equipped with always-on active anti-
tampering system. Any attempt to open the product enclosure will
activate the anti-tamper triggers and render the unit inoperable and
warranty void.