8-19
PIN 10 OF
CN703
WF2
PIN 12 OF
CN703
WF4
PIN 6 OF
CN703
WF1
PIN 14 OF
CN703
WF6
PIN 8 OF
CN703
WF3
PIN 15 OF
CN703
WF5
PIN 14 OF
IC801
WF7
Main CBA Bottom View
BA81N0F01022-1
Because a hot chassis ground is present in the power
supply circuit, an isolation transformer must be used.
Also, in order to have the ability to increase the input
slowly,when troubleshooting this type power supply
circuit, a variable isolation transformer is required.
For continued protection against risk of fire,
replace only with same type 4 A, 125V fuse.
CAUTION ! :
ATTENTION :
Utiliser un fusible de rechange de m
ê
me type de 4A, 125V.
4A/125V
CAUTION !
Fixed voltage (or Auto voltage selectable) power supply circuit is used in this unit.
If Main Fuse (F601) is blown , check to see that all components in the power supply
circuit are not defective before you connect the AC plug to the AC power supply.
Otherwise it may cause some components in the power supply circuit to fail.
NOTE:
The voltage for parts in hot circuit is measured using
hot GND as a common terminal.
Summary of Contents for SLC195EM8
