Chapter 2 Preliminary Before Installation 11
SmartCabinet Integrated Solution User Manual
1) Loosen the fixing nuts on the four feet bolts to raise the feet, and the four castors will bear the weight, refer to
3.1 Installing Cabinet Components
.
2) Place a slope in front of the front or rear door, and connect it with the pallet, as shown in Figure 2-1.
3) Push the cabinet slowly from the pallet down to the ground along the slope.
4) Place the cabinet on the preserved position, and adjust the feet fixing nuts till the cabinet is level.
Pallet
Place a slope
and connect it
with the pallet
Pallet
Slope
Push the cabinet
slowly from the pallet
down to the ground
along the slope
Figure 2-12 Removing the pallet
Note
1. When removing the pallet, you need to prepare the slope or similar device by yourself.
2. The whole cabinet is very heavy, so take precautions when pushing the cabinet from the pallet down to the ground along the
slope, to avoid accidental collapse.
Inspection
After unpacking the components, verify that all the accessories are included according to the packing list and there is
no apparent damage on the components. If any component is absent or damaged, report to the carrier immediately. If
any covert damage is found, report to the carrier and the local service center of the supplier.
