2
Safety Instructions
WARNING:
To avoid fire, shock, and serious personal injury, follow all instructions
carefully.
1.
Read your Owner's Manual carefully before installing the Remote Control, Wall
Control, or Receiver. Retain Owner's Manual for future reference.
2.
Before servicing or cleaning the ceiling fan, switch power off at service panel and lock
service panel to prevent power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a warning device such as a
tag, to the service panel.
ADDITIONAL SAFETY INSTRUCTIONS FOR INSTALLATION
1.
To avoid possible electrical shock, be sure electricity is turned off at the main fuse or
circuit breaker box before wiring.
2.
Make certain no bare wires are exposed outside the wire connectors.
3.
All wiring must conform to National and Local Electrical Codes.
4.
Follow the recommended instructions for the proper method of wiring your new
Remote Control, Wall Control, or Receiver. If you feel you do not have enough
electrical wiring knowledge or experience, have your Remote Control, Wall Control, or
Receiver installed by a licensed electrician. Any electrical work not described in this
manual should be performed by a licensed electrician.
WARNING
!
DATE CODE:
The date code of this fan may be found on the box, stamped in ink on a white label.
You should record this data above and keep it in a safe place for future use.
INSTRUCTION TO THE USER (if device contains a digital device)
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This equipment has been certified to comply with the limits for a class B computing device,
pursuant to FCC Rules. In order to maintain compliance with FCC regulations, shielded cables
must be used with this equipment. Operation with non-approved equipment or unshielded
cables is likely to result in interference to radio and TV reception. The user is cautioned that
changes and modifications made to the equipment without the approval of manufacturer could
void the user’s authority to operate this equipment.
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
BP7253-2 4/28/06 11:58 AM Page 2
