12
13
Unsuccessful connection
Red and green lights flash alternately again.
This means device has returned to AP
mode. This is common, you may have to try
even 10-15 times, so please be patient. This
is common issue in Wi-Fi networks.
Please start again from step 1. Check that
your computing device has automatical-
ly returned connection to your home Wi-Fi.
You need to search again for available Wi-Fi
networks and reconnect to EMFIT QS.
With your next attempt(s) you probably can
skip step 3 as your laptop/tablet/smart-
phone remembers the EMFIT QS password.
Red and green lights are flashing alternately.
Device is again at AP mode.
Please don’t get confused if your browser
says “http://192.168.1.3 is not replying.” It is
because your computer probably switched
automatically to your home Wi-Fi and there is
no device in that address in Internet.
Check however again that you write your own
home Wi-Fi network password correctly. Also,
if after few attempts still no success, check
that your router is not 5 GHz version only or
operating at channels 12-13. For troubleshoot-
ing, see Main Manual page 37.
You may also get reply from some other than
EMFIT QS device. For example if you have IP
camera.
Connect to Wi-Fi
…continued
Register your device
After successful Wi-Fi connection, it is time to register your device.
Go to
https://qs.emfit.com
and click “Register your device”.
Locate your serial and PIN
numbers on the back of the
device.
YOUR SERIAL NUMBER
YOUR PIN NUMBER
Insert serial number and PIN number of your device.
PASSWORD TO YOUR DEVICE (AP ACCESS POINT)
YOUR SERIAL NUMBER
YOUR PIN NUMBER
Click “next”.
1
2
3
