Diagram 1:
Quik-Connect cable orientation.
The Quik-Connect cable should be installed as shown,
with the arrow on the connector facing up.
Connector sequence (Arrow as Pin 1):
Orange (pin 1)
Blue
(pin 2)
Green
(pin 3)
Bare
(pin 4)
Yellow
(pin 5)
White
(pin 6)
Red
(pin 7)
Diagrams 2A / 2B:
These two diagrams show how the push/pull pot can be wired two different ways. Diagram 2A shows the
switch wired so that when the knob is up, the dual coil is on, and when the knob is down, the single coil is on.
In Diagram 2B, when the knob is up the single coil is on, and when the knob is down, the dual coil is on.
NOTE: There are two separate pickups in the MMTW housing, and each pickup has two wires. The single
coil uses the white and yellow wires, and the dual coil uses the green and blue wires.
DIAGRAM 2A
DIAGRAM 2B
Knob up: Dual coil on
Knob up: Single coil on
Knob down: Single coil on
Knob down: Dual coil on
Pickup Output
White
Green
Yellow
Orange
Blue
Pickup Output
White
Green
Orange
Blue
Pickup Output
White
Orange
Blue
Shield
T one
V olume
0.1mf
B ottom V iew
E MG -MMT W Diagram 3
1 V olume, 1 T one
Pickup Output
White
Green
Yellow
Orange
Blue
Pickup Output
White
Green
Yellow
Orange
Blue
Pickup Output
White
Green
Yellow
Orange
Blue
Note: Connect red wire from pickup cable to red wire of battery clip.
Shield
B lack
R ed
Pickup Output
Green
Blue
Orange
Pickup Output
White
Orange
Yellow
Pickup Output
Orange
Shield
