11
6. OPERATIONS
6.1 Zeroing the display
You can press the “
ZERO”
key to set the zero point from which all other weighing and
counting is measured, within 4% of power up zero. This will usually only be necessary when
the platform is empty. When the zero point is obtained the display will show the indicator for
zero.
The scale has an automatic re-zeroing function to account for minor drifting or accumulation
of material on the platform.
However you may need to press the “
ZERO”
key to re-zero the scale if small amounts of
weight are shown when the platform is empty.
Note: Zeroing function is possible to operate only when the scale is stable with “
”
6.2 Unit selection
You can choose the desired unit by pressing “
UNIT/Clear”
key. The display will cycle
through the options: g, kg, lb, oz and back to g.
6.3 Taring
Before Tare function is used, if zeroing the scale is needed, press the “
ZERO”
key. Then the
indicator of zero will be on.
Ɣ
Place a container on the platform, a value for its weight will be displayed.
Ɣ
Press the “
TARE/Enter”
key to tare the scale. The weight that was displayed is stored as
the tare value and that value is subtracted from display, leaving zero on the display.
The
“
NET
” indicator will be on.
859715-25-35 en ma 2012-07
