1
E
n
g
li
sh
Damage can occur to the unit or surrounding items if unit is tipped.
Use a ramp if loading or unloading the unit from a height of more
than 1" (30.5 cm).
lIftInG
Always use two people when lifting and lift from the recommended
lift points (N).
WARNING: Risk injury from lifting. Unit weighs more than 160 lbs.
(72.6 kg) Do not move or lift without assistance.
MoVInG
1. Grasp handle (O) of compressor, and lift compressor high
enough so unit can be rolled on the front tire(s).
WARNING: Risk of unsafe operation. Ensure proper footing and
use caution when rolling compressor so that unit does not tip or
cause loss of balance.
. When location is reached slowly lower rear of compressor to
ground. Always store compressor in a horizontal position.
note: Should the unit tip over, hard starting and smoking will occur
due to oil spillage.
PrEPArAtIon For uSE
Pre-Start Checklist (Fig. 1)
1. Ensure engine ON/OFF switch (C) is in the OFF position.
. Ensure air tank is drained, see
draining Air tank under
Maintenance.
3. Ensure the drain valve (J) is closed.
4. Ensure safety valve (I) is functioning properly, see
Checking
safety Valve under
Maintenance.
5. Check pump oil level, see
Compressor Pump oil under
Maintenance.
CAUTION: Do not operate without oil or with inadequate oil. EMGLO
is not responsible for compressor failure caused by inadequate oil.
6. Check engine's oil and fuel level, see engine's instruction manual
for correct procedures.
7. Visually inspect drive belt. Replace belt if frayed, cracked, or worn.
note: Outer belt cover must be removed to inspect drive belt.
8. Visually inspect air hose(s), replace if needed.
9. Ensure all guards, covers, and labels are in place, legible (for
labels) and securely mounted. Do not use compressor until all
items have been verified.
Initial Set-up (Fig. 1)
WARNING: Do not operate this unit until you read and understand
this instruction manual and the engine instruction manual for safety,
operation and maintenance instructions.
breAK-In ProCedure
CAUTION: Risk of property damage. Serious damage may result if
the following break-in instructions are not closely followed.
this procedure is required:
• Before the air compressor is used for the first time.
• When the unloader valve has been replaced.
• When the compressor pump has been replaced.
the procedure:
1. Follow
Pre-start Checklist under
Preparation for Use
.
. Rotate the unloader's manual lock to the
open position to
prevent air tank pressure buildup.
3. Open the drain valve (counter-clockwise) fully to permit air to
escape and prevent air pressure build up in the air tank during
the break-in period.
