16
Analog Picture Mode (Satellite)
The Analog Picture mode is selected from the Spectrum Mode by selecting ‘1 Picture’
and then ‘2 Analog’ using the keypad. The knob tunes the desired frequency which is
displayed at the bottom of the LCD and ‘0 13/18V’ and ‘# 22kHz’ can be used from the
keypad to change polarisation and band.
This is a screenshot of TV5Monde PAL on Hotbird at 11322V.
Analog Picture Mode Functions
Invert) This switches between normal video used in the Ku band and inverted video
used in the C band. The selected position is displayed on the LCD.
Sound) This mutes or enables the sound. The audio volume and frequency are
adjusted using the small controls below the frequency knob.
Memory) This is for storing your various Analog channels. First tune in the correct
frequency to be saved. Then make sure that the memory will be saved to the correct
position shown on the LCD using the knob. Enter the Memory function with keypad
‘3 Memory’ and then use keypad ‘1 Save’. “SAVE. ARE YOU SURE ?” is shown and the
confirmation is keypad ‘1 Yes’. Use the text editor to add the memory position name.
After entering the name, use keypad ‘* Save’. The frequency, 13/18V, and 22kHz
state will be saved.
.
Atten) The Attenuator of 15dB can be inserted or off. The LCD shows the attenuator
state.
13/18V) Selection of the LNB power to 13V or 18V. The LCD shows the current
state at the top.
#. 22kHz) This sets the 22 kHz signal On or Off. The LCD shows the current state at
the top.