33
Channel Power Measurement (TV)
The digital output-level (in dB) of digital transponders (such as in digital terrestrial
transmissions) can be measured for saved spectrum samples.
(If the spectrum is not saved, then save the spectrum to a memory location by “Memory -
> Spectrum -> Save” )
Load a saved spectrum using “Memory -> Spectrum” and use the knob to select the
memory position and then press “Load”.
Press “Digital” and now use the knob to set the start frequency of the digital channel.
Press “Set strt” and then use the knob to set the stop frequency and press “Set strt” again.
(Digital transponders are normally 8 MHz wide)
The channel power and bandwidth are shown at the lower right of the TFT screen.