54
Appendix H – Specification
Satellite TV (uses SAT
Satellite TV (uses SAT
Satellite TV (uses SAT
Satellite TV (uses SAT----IN F
IN F
IN F
IN F----Connector)
Connector)
Connector)
Connector)
Input frequency: 920-2150MHz
Min Input Level: About 35 dBuV (noiselevel).
Max Input Level: About 90 dBuV.
Attenuation: 15 dB manual attenuator on/off.
Accuracy: ±1½ dB TV Accuracy: ±1dB (at +20 C)
Spectrum bandwidth from 250MHz to 1230MHz
Frequency display: Yes, IF default. All standard LNB LO can be used
Display of signal level (Analog): dB-level on Spectrum display
Pitch-tone on loudspeaker for dish/antenna signal strength optimisation
Display of signal level (Digital): SNR (signal/noise-ratio), BER (bit error rate), MER
Constellation diagram (DVB-S, DVB-S2, QPSK, 8PSK normal, 8PSK rotated)
Symbol rate display: 1 to 45 MSymbols/sec
Satellite identification: Yes, NIT display (Network Information Table) according to
the DVB standard. Identifies Satellite Name and position. Name of TV and radio channels from SDT
(Service Description Table)
Analog TV/Audio standard: Multi TV/Audio (PAL, NTSC, SECAM).
Digital DVB-S decoder. MPEG-2 display (MPEG-4 not decoded)
Ku - C-band: Yes, selectable from LNB type defined.
Audio bandwidth : Adjustable between 5.5 MHz and 8.5 MHz
Memory: -100 spectrum pictures can be stored with name.
Stored spectrum can be mixed for easy identification of satellite.
Maxhold function.
Power out: Yes, 13-18V for LNB can be adjusted.
22 kHz tone: Yes, on/off.
DiSEqC Yes, all 1.0 and 1.1. Also Toneburst on/off.
DiSEqC actuator: Built in positioner for DiSEqC 1.2, SatScan and SatSelect.
DiSEqC Goto X for USALS operation.
TV/CATV (uses TV
TV/CATV (uses TV
TV/CATV (uses TV
TV/CATV (uses TV----IN F
IN F
IN F
IN F----Connector)
Connector)
Connector)
Connector)
Input Frequency: 2–900MHz
Min Input Level: About 35 dBuV (noiselevel).
Max Input Level: Picture = 110 dBuV Spectrum = 120 dBuV
Attenuation: 0dB to 45dB in 1 dB step (Automatic or manual setting)
Accuracy: ±1dB (at +20 C)
Resolution Bandwidth: 1MHz or 300kHz
Video Bandwidth: 100kHz, 1-kHz, 1kHz, or 100Hz
Analog TV/Audio standard: Multi TV/Audio (PAL, NTSC, SECAM).
Teletext (CEEFAX): Yes
Power for Active Antennas: Yes – 12VDC to 24VDC in 2V steps
DVB-T picture: Yes MPEG-2 display (MPEG-4 not decoded)
SNR Measurement Function
Digital Channel Power Function
Memory for Spectrum storage, Channel storage and Favorite storage
General
General
General
General
Input impedance: 75 Ohm, F Connector
Picture-screen: 5. 16:9 TFT color display.
Menus: On LCD 64x128 next to the monitor.
PC-connection Yes, RS232-output.
Battery: Li-Ion, rechargable 12v, 3.5 amp/hour
Operational: About 1.5 hour on a fully charged battery.
Weight: About 3 kg including battery and carrying-case.
Accessories: Nylon carrying-case.
Power-supply of 220v/13.5v, 1.7amp.
Car-charger.