9
Output Relay On Delay Time ( Default = 0 )
It determines how long output relay will be active. If it is 0000 second, then it operates
indefinitely.
= .
It can be adjusted from to minute/second. This parameter is
active only if
Buzzer Function Selection Parameter ( Default = 0 )
if this parameter is selected 0, Buzzer is inactive. Adjustable 16 different buzzer sounds.
It can be adjusted from 0 to16.
Buzzer is active during this time ( Default = )
Buzzer stays active during this time. It can be adjusted from 1 to 99 seconds When this
parameter is 1, if decrement button is pressed, is observed. In this condition
buzzer is active till buzzer Stop button is pressed.
Programming Section Access Password
.
( Default = 0 )
It is used for accessing to the programming section. It can be adjusted from 0 to 9999. If it is
selected 0, password will not be asked
Data Record
( Default = 1 )
Timer count value is saved to memory when power is disconnected and restored
on power up.
Timer count value is not saved to memory when power is disconnected. When
power up, Set value is shown on the screen.
Maximum Set Value Parameter ( Default = 01:00)
Maximum set value for set time value.
It can be adjusted from to .
It can be adjusted from to .
( If time value is monitored in miliseconds. )
( If time value is monitored in Hours or
Minutes. )
Timer Counting Direction
( Default =
1
)
Timer upcount. 0 to Set value.
Timer Downcount. Set value to 0.
Button Protection Parameter
0
( Default = )
Button protection is not active.
Buttom protection is active for Timer set value.
