REPLACEMENT OF THE REGULATOR
WITH A FLOW METER CARTRIDGE
THE NEW TRANSFORMABLE EMMETI LOCKSHIELD CAN BE COMBINED
WITH A FLOW METER CARTRIDGE
• WHILE THE SYSTEM IS RUNNING;
• WITHOUT WATER LOSS;
• SIMPLY AND QUICKLY.
3
NEW DOUBLE REGULATING LOCKSHIELD
EMMETI HAVE EVOLVED A NEW AND SUPERIOR LOCKSHIELD DESIGN. THIS
ALLOWS EASIER, QUICKER AND MORE ACCURATE ONSITE SETTING OF THE
CORRECT FLOW. IT IS MORE ACCURATE AT MAINTAINING THE CORRECT LOW
FLOW, WHEN SET TO A SMALL APERTURE.
YOU NO LONGER NEED TWO SEPARATE TOOLS TO ADJUST TO A SUITABLE
FLOW RATE. FURTHER, THIS LOCKSHIELD CAN BE UPGRADED ON SITE TO
BECOME AN INTEGRATED FLOW METER AND LOCKSHIELD.
ADJUST THE LOCKSHIELD AS FOLLOWS:
THE LOCKSHIELD IS SUPPLIED IN THE CLOSED POSITION.
• REMOVE THE CAP
• TURN THE CAP OVER, AND, USING THE IMPRESSION INSIDE IT, TURN
THE ISOLATOR
ANTICLOCKWISE UNTIL REACHING A FULLY OPEN
POSITION.
• USE A 4 mm ALLEN KEY CLOSE THE ADJUSTMENT SCREW CLOCKWISE
, COMPLETELY, UNTIL REACHING THE END OF STROKE.
THE LOCKSHIELD IS NOW READY FOR FLOW SETTING.
• UNSCREW THE ADJUSTMENT SCREW ANTICLOCKWISE
, BY THE
DESIRED NUMBER OF TERMS (PLEASE USE GRAPH ON PAGE 17).
• INSERT THE CAP AGAIN.
IT IS NOW POSSIBLE TO SEAL THE CAP INTO POSITION USING LEAD,
TAKING ADVANTAGE OF THE HOLES PRESENT IN THE FINS
IN ORDER
TO FASTEN DIRECTLY TO THE MANIFOLD, PLUS MAKING TAMPERING
IMPOSSIBLE.
NOTE:
THE ISOLATOR
, IS NOT USED FOR CALIBRATION ONLY FOR ISOLATION.
REPLACEMENT OF THE REGULATOR WITH A MEASUREMENT CARTRIDGE:
• CLOSE THE ISOLATOR
USING CAP
. REMOVE THE CLIP WITH A SCREWDRIVER.
• REMOVE THE REGULATOR
USING AN ALLEN KEY AND SCREWDRIVER.
• INSERT THE MEASUREMENT CARTRIDGE AND REPLACE THE CLIP.
PLACE THE WHITE RING NUT OVER THE CARTRIDGE.
1. MANIFOLD SYSTEM
GB
GB
