4
Note:
The S/S button is functional for the active time visible on the display (T1/T2). You can
switch between them using the T1/T2 button.
Interrupting/resetting the time before expiration
Using the S/S button, you can put the time measurement on hold; pressing S/S
again will reactivate it. If you need to reset the time interval, first press S/S, and
then M and S simultaneously.
Memory of the last pre-set value and resetting the memory
The timer has a memory which keeps the last pre-set value. You can start the
measurement with this value at any time by pressing S/S. If you wish to pre-set
a new value, reset the old one by pressing M and S simultaneously.
Stopwatch
The timer can be used as a stopwatch, separately for each of the two times. When
there is value 0:00 00 set on the display, press T1/T2 for time selection, followed by
pressing S/S. The stopwatch will be started. Pressing S/S will stop the stopwatch;
pressing M and S simultaneously will reset the displayed value. The maximum time
measured by the stopwatch is 99 hours, 59 minutes, and 59 seconds.
Note:
The timer can be used as a timer for one time and stopwatch for the other.
Location
The timer is equipped with a magnet on the back side to place it on a vertical
metal surface. Alternatively, a stand rest on the back side can be used.
Maintenance
• Carefully read the instructions before using the timer.
• Do not expose the timer to excessive force, shocks, dust, high temperature or
humidity. Such influences may interfere with the functions, shorten the lifetime
or damage the battery.
• Do not interfere with the insides of the timer – you can damage it and void the
warranty.
