2
GB | DVB-T/T2 outdoor antenna
Safety Instructions and Warnings
The product is designed to serve reliably for many years
if used properly.
• Read the user manual thoroughly before use.
• Do not place the product in locations prone to
vibration and shocks – these may cause damage.
• Do not place any open flame sources on the prod-
uct, e.g. a lit candle, etc.
• To clean the product, use a slightly moistened soft
cloth. Do not use solvents or cleaning agents - they
could scratch the plastic parts and cause corrosion
of the electric circuits.
• In the event of damage or defect of the product, do
not perform any repairs by yourself. Have it repaired
by the retailer you bought it from.
• This device is not intended for use by persons
(including children) whose physical, sensory or
mental disability or whose lack of experience or
knowledge prevents them from using it safely.
Such persons should be instructed in how to use
the device and should be supervised by a person
responsible for their safety.
Do not dispose with domestic waste. Use special
collection points for sorted waste. Contact local
authorities for information about collection
points. If the electronic devices would be disposed on
landfill, dangerous substances may reach groundwater
and subsequently food chain, where it could affect
human health.
Hereby, EMOS spol. s r.o. declares that the radio
equipment type J0658 is in compliance with Directive
2014/53/EU. The full text of the EU declaration of con-
formity is available at the following internet address:
http://www.emos.eu/download.
Package Contents
Antenna
Antenna mount/stand
Power supply
Coaxial Cable
Device Description
Digital active DVB-T/T2 antenna for indoor and outdoor
use with low-noise amplifier
Installation
• When installing the antenna, use a mount or stand
depending on the intended use (fig. 1–4)
• Connect the coaxial cable to the antenna.
• Connect the coaxial cable to the voltage divider
(fig. 6).
• Plug the voltage divider connector to the TV receiv-
er or set-top box.
• Connect the power supply to a 230 V power socket
(fig. 6).
• The antenna can also be powered from the TV
or set-top box if the device supports this feature
(fig. 5).
• Connect the coaxial cable from the antenna to the
TV receiver or set-top box (fig. 5).
• Keep changing the placement of the antenna while
monitoring the signal quality on the connected TV.
• To achieve the best reception quality, place the
antenna onto an elevated spot.
Technical Specifications
Frequency range: VHF/DAB/UHF 174–230 MHz,
470–790 MHz
RF output impedance: 75 Ω
Power supply: DC USB 5 V/550 mA
1
2
3
5
4
6
H
V
