Emos J0664, Manual

2

GB | DVB-T/T2 indoor – outdoor antenna

Safety Instructions and Warnings 

The product is designed to serve reliably for many years 

if used properly.

•  Read the user manual thoroughly before use.

•  Do not place the product in locations prone to 

vibration and shocks – these may cause damage.

•  Do not place any open flame sources on the prod-

uct, e.g. a lit candle, etc.

•  To clean the product, use a slightly moistened soft 

cloth. Do not use solvents or cleaning agents - they 

could scratch the plastic parts and cause corrosion 

of the electric circuits. 

•  In the event of damage or defect of the product, do 

not perform any repairs by yourself. Have it repaired 

by the retailer you bought it from. 

•  This device is not intended for use by persons 

(including children) whose physical, sensory or 

mental disability or whose lack of experience or 

knowledge prevents them from using it safely. 

Such persons should be instructed in how to use 

the device and should be supervised by a person 

responsible for their safety. 

Do not dispose with domestic waste. Use special 

collection points for sorted waste. Contact local 

authorities for information about collection 

points. If the electronic devices would be disposed on 

landfill, dangerous substances may reach groundwater 

and subsequently food chain, where it could affect 

human health.

Hereby, Emos spol. s r. o. declares that the radio 

equipment type J0664 is in compliance with Directive 

2014/53/EU. The full text of the EU declaration of con-

formity is available at the following internet address: 

http://shop.emos.cz/download-centrum/.

Package Contents

Antenna

Antenna mount/stand

Power supply

Coaxial cable

Device Description

Digital active DVB-T/T2 antenna for indoor and outdoor 

use with low-noise amplifier

Installation

•  When installing the antenna, use a mount or stand 

depending on the intended use (fig. 1–4)

•  Connect the coaxial cable to the antenna.

•  Connect the coaxial cable to the voltage divider 

(fig. 6).

•  Plug the voltage divider connector to the TV receiv-

er or set-top box.

•  Connect the power supply to a 230 V power socket 

(fig. 6).

•  The antenna can also be powered from the TV 

or set-top box if the device supports this feature 

(fig. 5).

•  Connect the coaxial cable from the antenna to the 

TV receiver or set-top box (fig. 5).

1

2

3

4

5

6